Lexicon RV-8 - Manual (Page 184)

Mode Adjust Lexicon
6-42
LISTENING MODE MENU OPTION and PARAMETER DESCRIPTIONS (continued)
• This parameter is available in 5.1 PLIIx MOV, 5.1 PLIIx MUS,
DOLBY DIGITAL EX and DOLBY DIGITAL modes.
• When the Shift command bank is activated, pressing the
remote control DOLBY button while a 5.1-channel Dolby
Digital source is present activates the Dolby DIGITAL EX or
Dolby DIGITAL listening mode. Subsequent presses adjust the
EX DECODING parameter, cycling through the AUTO, ON and
OFF settings.
FRONT STEERING OFF, MSURR, MUSIC, FILM
Adjusts front steering between the front left, front right, and center
speakers. When set to FILM, maximum front steering is applied to
the center channel. When set to MUSIC, moderate front steering is
applied. When set to MSURR, minimum front steering is applied.
When set to OFF, no front steering is applied. It is recommended
that you set this parameter to FILM for film and broadcast sources
and to MUSIC, MSURR or OFF for music sources. Available in L7 TV,
L7 MUSIC, L7 MUSIC SURR, all 5.1 L7 modes and all DTS L7 modes.
INPUT BALANCE L< to <|> to >R
Controls the balance of the selected stereo analog audio input
connectors, compensating for audio input sources with audible
channel imbalance. Available in PANORAMA mode.
LFE MIX –20.0 or -10.0 to +0.0dB
Controls the output level of LFE information – the .1 channel in a 5.1-
or 6.1-channel input source – that is sent to the audio output labeled
Subwoofer. Low frequencies from up to seven other channels might be
combined with the LFE information to create the subwoofer output
signal, which significantly increases subwoofer output levels.
Careful adjustment of this parameter allows achievement of proper
tonal balance and reduces the risk of subwoofer overload. When the
speaker setup does not include a subwoofer, LFE information is mixed
into speakers for which the corresponding CUSTOM SETUP menu
parameter is set to FULL or to the lowest crossover points. Available in
all Dolby Digital modes except MONO modes (5.1 MONO LOGIC, 5.1
MONO SURR, 5.1 MONO) and all DTS modes.
LISTENER POS –127 to +127
Compensates for primary listening positions that are not centered
between the front left and right speakers. Each increment within the
–127 to +127 parameter range represents about one-third of an inch.
Refer to the Calibration section that begins on page 5-13 for more
information. Available in PANORAMA CALIBRATION mode.
Note:
The LISTENER POS parameter range might extend past the location of the
front left and right speakers.
LIVENESS 30ms to 20.2s
Depends on the SIZE parameter setting. The LIVENESS parameter
adjusts the amount of effect recirculation. Higher settings mimic
more reflective surfaces and increase decay time. Available in
NIGHTCLUB and CONCERT HALL modes.
LOW FREQ WIDTH –25 to +25dB
Applies low-frequency spatial correction to the input signal. This
correction is applied to uncorrelated input signals below 60Hz.
Available in PANORAMA mode.