Lexicon RV-8 - Manual (Page 232)

Appendix C Lexicon
C-14
5. To edit DEVICE button text, skip Steps 3 and 4 and press the PAGE
button before selecting the Device button.
6. The character to be changed will blink. To change the character
use the number pad buttons on the remote control. The
characters assigned to each number pad button are shown below.
It will cycle to a different character each time the same number
pad button is pressed.
Note:
Move the cursor left or right using the joystick. Delete a current
character by using the cursor down on the joystick. Using the “cursor
down” technique is a quick way to delete all of the text on a label.
7. Save the text by pressing the button you were writing on (the same
function button selected in step 3 or device button in step 4).
8. Exit from Edit mode by pressing the HOME button and then exit
from the SETUP mode by pressing the HOME button again.
EDIT TEXT FOR FAVORITE CHANNEL BUTTONS
To edit text for favorite channel buttons:
1. Go to the SETUP mode by pressing the HOME and ENT buttons
simultaneously for three seconds.
2. Press the EDIT button next to the LCD screen.
3. Press the FAV button and then the favorite channel button on
which you wish to write text. There are five LCD pages of favorite
channels. Select the page you wish to write on by pressing the
PAGE button.
4. The character to be changed on the button you selected will blink
and you can change the character using the number pad buttons
on the remote control. The characters assigned to each number
pad button are shown in the previous column. It will cycle to a
different character each time the same number pad button is
pressed.
5. Save the edited text by pressing the same function button selected
in step 4.
6. Exit from Edit mode by pressing the HOME button and then exit
from the SETUP mode by pressing the HOME button once again.
RECALLING THE PREPROGRAMMED THREE-DIGIT NUMBER
1. Go to the SETUP mode by pressing the HOME and ENT buttons
simultaneously for three seconds.
2. Press the RECAL button next to the LCD screen.
3. The LCD display will alternately flash device names and the three-
digit code number assigned to the device for 10 seconds and then
exit to the SETUP mode.
4. Before the 10 seconds are up, pressing the HOME button on the
remote will stop the flashing and exit to the SETUP mode.
5. Exit from SETUP mode by pressing the HOME button once again.
ERASING LEARNED BUTTONS
To erase learned buttons:
1. Go to the SETUP mode by pressing both the HOME and ENT
buttons simultaneously for three seconds.
2. Press the ERASE button next to the LCD screen.
3. Press the LEARN button.
1. A B C
5. M N O
9. Y Z (Blank)
2. D E F
6. P Q R
0. + - <>, etc
3. G H I
7. S T U
4. J K L
8. V W X