Lexicon RV-8 - Manual (Page 21)

RV-8 Basic Operation
2-9
putting the RV-8 into standby. The trigger output connector
(labeled 1) can be configured for remote or program operation. See
“Trigger Setup” on page 3-70 for more information.
13 RS-232 CONNECTORS
The RS-232 serial connector (1) provides serial control and is used to
perform configuration downloads and flash memory software
upgrades. The RS-232 connector (2) is reserved for future
developments.
14 MAIN ZONE AUDIO OUTPUT CONNECTORS
Provide analog audio output in the Main Zone. Eight connectors
labeled Front L/R, Center, Sub, Side L/R and Rear L/R are available.
15 IR IN CONNECTOR
Accepts input of IR signals from infrared distribution equipment.
One 3.5mm jack that accepts a stereo plug (Tip/Ring/Sleeve
connection) or mono plug (Tip/Sleeve connection) is available.
16 ZONE 3 AUDIO/VIDEO OUTPUT CONNECTORS
Provide analog audio/video output in Zone 3. One stereo analog
audio output (variable level) is available and can derive its source from
a variety of analog sources. One composite video output is available
and can derive its source from any composite or S-video source.
17 ZONE 2 DIGITAL AUDIO OUTPUT CONNECTORS
(S/PDIF)
Provides digital audio output in Zone 2. One S/PDIF coaxial and
one S/PDIF optical (Toslink) connector is available.
18 REMOVABLE ACCESS PANEL
Reserved for future developments.
19 AC INPUT CONNECTOR
Provides power to the RV-8 through the supplied power cord.
20 POWER SWITCH
Use the Power switch to connect or disconnect power from the AC
Input connector to the RV-8. The I and O positions represent “on”
and “off” status, respectively. When the RV-8 is powered on, the
front-panel Standby button or remote control On button can be
used to activate and deactivate standby mode. When the RV-8 is
powered off, standby mode is not available.
In the event of a power outage, the RV-8 will display a BROWNOUT,
CYCLE POWER message. To turn the unit back on, use the rear-
panel power switch. In this instance, the front-panel StandBy switch
has no effect.