Lexicon RV-8 - Manual (Page 96)

Setup Lexicon
3-48
PERFORMING AUTOMATIC CALIBRATION
STEP DISTANCES DISTANCES & LEVELS LEVELS
1
2
AUTO SPEAKER SETUP SPEAKER SETUP
SET CROSSOVERS
CHECK MICROPHONES
AUTOMATIC
MANUAL
CUSTOM SETUP
40 Hz
60 Hz
60 Hz
60 Hz
40 Hz
OFF
N/A
APART
AUTO SPEAKER SETUP
DISTANCES & LEVELS
SET CROSSOVERS
BEFORE CALIBRATING
DISTANCES
OUTPUT LEVELS
PLACE MICROPHONES
AROUND PREFERRED
LISTENING POSITIONS
CUSTOM SETUP
40 Hz
60 Hz
60 Hz
60 Hz
40 Hz
OFF
N/A
APART
AUTO SPEAKER SETUP
!CAUTION!
HIGH AUDIO LEVELS
TEST WILL BEGIN IN
10
YOU WILL HAVE 10 SEC
TO LEAVE THE ROOM OR
SIT QUIETLY
PRESS TO BEGIN
COUNTDOWN
PRESS TO SKIP
COUNTDOWN
Follow the procedures in the appropriate table column for the desired type of automatic calibration.
MAIN MENU
MODE ADJUST
AUDIO CONTROLS
TUNER PRESETS
SETUP
INPUTS
SPEAKERS
I/O CONFIG
DISPLAYS
VOLUME CONTROLS
TRIGGER
TUNER SETUP
LOCK OPTIONS
LIVE! CALIBRATION
SETUP
POWER MANAGEMENT
Select the SPEAKER SETUP menu AUTOMATIC option, as shown in the menu illustration above.
• If a microphone check is successful, the AUTO SPEAKER SETUP menu appears in the on-screen display. Press
the or arrow button to highlight the automatic calibration option you want. Then press the arrow button to select
this option. Refer to the table on page 3-36 for more information about automatic calibration options.
• If a microphone check is unsuccessful, one of the error messages shown to the right appears in the on-screen display, indicat-
ing that a successful microphone check is required before automatic calibration, and also the reason the previous check failed.
If this occurs, go back to “Connecting the Microphones” on page 3-37 and work your way back to this page.
MIC CHECK REQUIRED
FOR AUTO CALIBRATION
NO MICROPHONE
DETECTED
The following AUTO SPEAKER SETUP messages are displayed before automatic calibration begins:
• The !CAUTION! HIGH AUDIO LEVELS message indicates that the RV-8 generates loud calibration noise signals during automatic calibration. If the sig-
nals become too loud, press the arrow button to cancel automatic calibration. Press the arrow button to open the next AUTO SPEAKER SETUP
menu.
• The countdown display notifies you that automatic calibration will begin in 10 seconds. The primary reason for the 10 second delay is to give you time
to leave the listening space before automatic calibration begins. If you choose to remain in the room, your movements could affect the calibration
results. If you leave the room, you can return in about 10 minutes (the calibration procedure should be completed). Press the
arrow button to
skip the countdown and begin automatic calibration. The RV-8 automatically activates automatic calibration when the countdown ends.