Plasmon V15 - Manual (Page 125)

Appendix C
Page 123
32 Barcode module failure. The
barcode module is not func-
tioning properly. Make sure the library and tape drives are not being used
by any host, then reset the library from the operator
panel.
If the error persists, the barcode module may need to be
replaced. You may need to supply a diagnostic listing;
you may need new firmware. Contact your service pro-
vider.
34 RRC sensor failure. The
robot gripper sensor failed. Open the door and remove the magazines. Look for any-
thing that might be obstructing the gripper or the robot’s
path along the reach axis.
Make sure the library and tape drives are not being used
by any host, then reset the library from the operator
panel.
If there are no obstructions and the error persists, the
robot may need to be replaced. Contact your service
provider.
35 RRC communication fail-
ure. The library cannot com-
municate with the robot
gripper command processor. Make sure the library and tape drives are not being used
by any host, then reset the library from the operator
panel.
If the error persists, the robot may need to be replaced.
Contact your service provider.
36 RRC command reject. An
invalid command was sent to
the robot command processor. Make sure the library and tape drives are not being used
by any host, then reset the library from the operator
panel.
If the error persists, the robot may need to be replaced.
Contact your service provider.
38 Cannot load drive. The robot
cannot push the cartridge far
enough to load it into the tape
drive. Open the door and remove the magazines. Look for any-
thing that might be obstructing the robot along its reach
axis.
Make sure the library and tape drive are not being used
by any host, then reset the library from the operator
panel.
If the error persists, contact your service provider.
39 RRC Command Failure. Make sure the library and tape drives are not being used
by any host, then reset the library from the operator
panel.
If the error persists, the robot may need to be replaced.
Contact your service provider.
LCD
Code
Description Corrective Action