Plasmon V15 User Manual
Page 129
Appendix C
Page 127
120
Drive cmd error. The tape
drive failed to respond to a
command from the library.
Make sure the library and tape drives are not being used
by any host, then reset the library from the operator
panel.
If the error persists, contact your service provider. You
may be asked to supply a diagnostic listing; you may
need new firmware or a new controller card.
130
SCSI chip error: SCSI unex-
pected int; SCSI int stuck
error. There was a SCSI chip
failure.
Make sure all SCSI devices are of the same configura-
tion (see SCSI Bus Considerations in Appendix B for
more information).
Make sure the library and tape drives are not being used
by any host, then reset the library from the operator
panel.
If the error persists, contact your service provider. You
may be asked to supply a diagnostic listing; you may
need new firmware or a new controller card.
131
132
133
134
135
136
137
140
Flash erase fail. The library is
unable to erase the flash
EEPROM.
Make sure the library and tape drives are not being used
by any host, then reset the library from the operator
panel.
If the error persists, contact your service provider.
141
Flash program fail. The
library is unable to program
the flash EEPROM.
142
Checksum miscompare. The
flash EEPROM checksum was
bad.
143
Invalid header data. The
flash EEPROM header was
invalid.
144
Can’t program RRC card.
The RRC code load failed.
Reset the library from the operator panel. If the error per-
sists, contact your service provider.
194
All slots are full. The robot
could not find an empty car-
tridge slot.
Open the library door and remove at least one cartridge
from a magazine or fixed slot.
Make sure the library and tape drives are not being used
by any host, then reset the library from the operator
panel.
If the error persists, contact your service provider.
195
All slots are empty. The robot
could not find a cartridge to
pick in Demo mode.
Open the library door and insert at least one cartridge in
a magazine.
LCD
Code
Description
Corrective Action