Plasmon V15 - Manual (Page 38)

Plasmon V 15 AIT Tape Library User Manual
Page 36
The Main Menu selections are described in the following table.
Table 2. Main Menu Selections
Menu
Selection
Description
Cartridge Inven-
tory Displays the library’s current cartridge inventory on three
sequential screens.
Security
(Enabled/
Disabled) Allows you to enable or disable security from the LCD with a
password. This prevents unauthorized personnel from disrupt-
ing library operation through either the LCD or the SCSI bus.
Robot Mode Displays the current robot control mode (SCSI, LCD, Sequen-
tial, or Console) and allows you to change the mode.
Config (Configu-
ration) Menu Allows you to change the serial port baud rate, set the auto-
clean function, reserve a fixed slot for a cleaning cartridge, and
choose whether the library scans the cartridge barcode labels
after power up.
SCSI Menu Displays the SCSI IDs for the library and tape drive. Allows you
to set the SCSI IDs, emulation mode, and SCSI parity check-
ing.
Sequential Mode Allows you to select options for sequential mode operation, if
you intend to operate the library as a sequential stacker
device.
Ethernet Menu Allows you to configure the library for operation on an Ethernet
network.
Library Informa-
tion Displays information about the library code versions, system
statistics, and system sensors.
Drive Menu Allows you to view the status of the tape drives. This menu
also allows you to connect the serial port to the tape drives to
perform diagnostics or upgrade firmware.
Demo Menu Allows you to run various demonstration programs to observe
how the library operates.
Command Menu Allows you to issue commands for basic robot motion opera-
tions and perform diagnostic tests.
Park and Unlock
for Shipping Moves the robot to the park position for shipment and unlocks
the door.