Plasmon V15 - Manual (Page 70)

Plasmon V 15 AIT Tape Library User Manual
Page 68
5. Press [ENTER]. The following screen appears.
6. Use the up or down arrow keys to indicate whether you want the tape drive used in the demo,
then press [ENTER]. If you selected Yes, the following screen appears.
7. Use the up or down arrow keys to indicate whether you want cartridges loaded in the drive or
just inserted into the drive opening during the demo. Press [ENTER}. An informational
message displays, then the following screen appears.
8. Use the arrow keys to set the number of moves (the left and right arrow keys move across the
columns; the up and down arrow keys change the numbers). Then press [ENTER].
The library begins the demo and displays status messages. If you want to abort a demo in
progress, press [ESCAPE]. Press [ESCAPE] again to return to the Demo Menu.
Using the Command Menu
The Command Menu provides basic exercising functions for components in your library. Refer to the
diagram in this chapter showing the element indexes. These numbers correspond to the library
components and are necessary for some tests.
To perform diagnostic commands:
1. If necessary, disable security.
2. Change the control mode to LCD.
3. From the operator panel keypad, press [MENU] to display the menus. Press the down arrow
key until “Command Menu” displays, as shown below.
4. Press [ENTER]. The LCD displays the first diagnostic test.
U s e
D r i v e ? N ↑
L o a d
D r i v e ? N ↑
0 0 0 0 0 1 0
←
b
→
 C o m m a n d
M e n u
 M o v e
C a r t r i d g e