Plasmon V15 - Manual (Page 96)

Plasmon V 15 AIT Tape Library User Manual
Page 94
Using Touch-up Paint on the Housing
A paint kit is available for touching up nicks and scratches on the finish. For ordering information, see
Contacting Plasmon at the back of this manual.
Cleaning the Library
The only library component that should be cleaned is the tape drive. Instructions for cleaning the tape drive
are provided in the Tape Drive Operation chapter.
CAUTION
The library’s internal components are lubricated at the factory and
should not be cleaned or relubricated. To protect the internal
components from dust, keep the library door closed and locked.
Replacing the Tape Drive
This section describes how to replace the tape drive. Tape drive kits are available from Plasmon. The tape
drive is shipped to you in the drive carrier. You cannot install a tape drive into the library without a drive
carrier.
WARNING
Removing a drive or access panel with the library powered on may
result in exposure to the 650 nm, 1.2 mW Class 2 pulsed radiation
laser scanner. Always power off the library and remove the AC power
cord before removing or installing an access panel or drive.