Plasmon V15 - Manual (Page 130)

Plasmon V 15 AIT Tape Library User Manual
Page 128
198 Robot full before command.
The robot, all slots, and all
drives contain a cartridge
when an Initialize Element
Status command was
requested. Open the library door and remove the cartridge from the
robot gripper.
Reset the library.
199 Tape in drive. A cartridge is
already loaded in the destina-
tion tape drive. Eject the cartridge from the tape drive and remove it
manually (see Ejecting a cartridge Manually in Chapter
6).
Note: This error only occurs when the library is operat-
ing in Sequential mode.
200 X axis does not move. The
robot could not move along
the horizontal axis. Open the door and remove the magazines. Look for any-
thing that might be obstructing the robot’s path along the
horizontal axis.
Make sure the library and tape drives are not being used
by any host, then reset the library from the operator
panel.
If there are no obstructions and the error persists, con-
tact your service provider.
201 X axis has failed home. The
robot could not return to the
home position along the hori-
zontal axis.
202 X axis position sensor
failed. The library could not
complete a move along the
horizontal axis.
203 X axis EOT fail. The library
could not detect the end-of-
travel sensor on the horizontal
axis. Open the door and remove the magazines. Look for any-
thing that might be obstructing the robot’s path along the
horizontal axis.
Make sure the library and tape drives are not being used
by any host, then reset the library from the operator
panel.
If there are no obstructions and the error persists, con-
tact your service provider.
204 X axis home sensor fail. The
library could not detect the
horizontal axis home sensor
(safe rotate position).
205 X axis scan failed. The library
could not complete a move
along the horizontal axis.
207 X axis cal fail. The robot posi-
tion along the horizontal axis
could not be calibrated.
213 Invalid Xcard configuration.
An invalid combination of
expansion cards is installed in
the library. Make sure the library and tape drives are not being used
by any host, then reset the library from the operator
panel.
If the error persists, contact your service provider. An
expansion card may not be properly installed or the
wrong card is installed.
LCD
Code
Description Corrective Action