Plasmon V15 - Manual (Page 25)

Hardware Installation
Page 23
Obtaining Accessories and Equipment
Make certain you have all the accessories and equipment for library operation, as indicated in the table
below. Many of these items are included in the library accessories box in the shipping carton. If necessary,
you can purchase these items from Plasmon (see Contacting Plasmon at the back of this manual).
Table 1. Accessories and Equipment
Selecting Cartridges
The Sony SDX-500 AIT-2 or SDX-700 AIT-3 tape drive reads and writes to the highly reliable AME
cartridges for AIT-2 or AIT-3 drives. AIT-2 or AIT-1 cartridges may be used in an AIT-3 drive, but degrade
performance. AIT-1 cartridges may be used in an AIT-2 drive, but degrade performance.The drive
automatically ejects cartridges it does not support.
Figure 8. AME Data Cartridge
Required Accessories and Equipment
Power cord Included with the library.
SCSI cables These items are included with the library. If you
want to use your own, see Appendix A for specifi-
cations.
SCSI bus terminator(s)
Barcode labels For libraries that have a barcode scanner, sample
barcode labels are included. For information
about preparing your own barcode labels, refer to
the Plasmon Barcode Label Specification for AIT
Cartridges. For information about approved bar-
code label vendors, visit www.plasmon.com.
(1)
(1) If you create your own barcode labels, be sure to follow the specification pre-
cisely. For best results, use a reliable vendor to create barcode labels.
Cartridges If cartridges are not included with the library, con-
tact Plasmon to purchase them.
Rack mount hardware If you want to install the library in a rack, contact
Plasmon for the required hardware.
4
3
0
0
0
0