Plasmon V15 - Manual (Page 27)

Hardware Installation
Page 25
WARNING
Before performing any installation or maintenance procedures, be
sure that the library power switch is in the off position and that the
power cord is disconnected from the library and the outlet.
WARNUNG
Vor der Ausfuhrung von Installations- oder Wartungsarbeiten ist
daraufzu achten, daß der Library-Netzschalter auf ”Aus” gestellt ist
und daß das Anschlußkabel non der Library und der Steckdose
entfernt ist.
ATTENTION
Avant de procéder a l’installation ou a l’entretien, vérifiez que
l’interrupteur d’alimentation de la librarie se trouve en position “arret”
et que le cable d’alimentation ne soit pas branché a la librairie et a la
prise de courant.
Preparing and Installing Cartridges
This section describes how to remove the packing material from the cartridge magazine, prepare
cartridges for use in the library, and install cartridges in the fixed slots and in the magazine.
Preparing Cartridges
1. If your library includes a barcode scanner, you can affix barcode labels to the cartridges. To
do this, position the label using the ridge on the cartridge for guidance, as shown below.
Figure 9. Barcode Label Placement
NOTE
To ensure barcode labels are read accurately, use labels with
checksum characters. Also, make sure the Verify Barcode
Checksums option is turned on.
Writ
Write
protect
4
3
0
0
0
0
Barcode Label