Installing the tape drive, Installing a tape drive – Plasmon V15 User Manual
Page 99
Advertising
Maintenance and Service
Page 97
3. Remove the drive carrier by grasping the handle and pulling it directly out of the library.
CAUTION
The drive carrier weighs five pounds (2.3 kg); make sure you support
the bottom of the carrier as you remove it.
Installing the Tape Drive
1. As shown in the following figure, insert the tape drive so that the SCSI connectors are at the
top. The drive should slide easily toward the front of the library.
Figure 32. Installing a Tape Drive
2. Tighten the captive screw to 8.0 inch-pounds (9.2 kg-cm) of torque.
Advertising