Powerware 9315 - Manual (Page 69)

USING THE CONTROL PANEL
EATON Powerware ® 9315 UPS (500–750 kVA) Installation and Operation Manual S 164201244 Rev E www.powerware.com 8-13
8.5.9 Port Setup Screen
Select Port 1 or Port 2 from the Setup menu to display one of the Port Setup screens.
The Port Setup screens allow you to specify settings for the two serial
communication ports on the UPS.
Figure 8‐12 shows the Setup Serial Port 1 screen.
Statistics Graphics Setup
Setup
Port 1
Uninterruptible Power System
UPS System Normal
Alarm: None
Notice: None
Events Meters
Setup Serial Port 1
RATE
9600 DATA/STOP
8 1
HANDSHAKING
XON / XOFF SAVE
NO
Time
MODE
TERMINAL
Port 2
48.5
Minutes
Battery
Language
4 MAY 1999 09:25:42
Figure 8‐12. Port Setup Screen
A small return arrow ( ) appears in the upper right corner of the information area of
the Port Setup screen. This arrow is a reminder that you can press the
pushbutton on the control panel to toggle the scroll bar between the menu box and
the information area. When the scroll bar is in the information area, the return arrow is
in the menu box. When the scroll bar is in the menu box, the return arrow is in the
information area.
When the scroll bar appears in the information area, you can use the pushbuttons to
change the port configuration. To change a setting, press the and pushbuttons
to highlight the setting you want to change. To scroll through the available options for
that setting, press the or pushbutton. To save the settings upon exit from this
screen, be sure the Save field is set to YES.
The setup screens for Port 1 and Port 2 are identical. For detailed information about
configuring the serial ports, see Chapter 12, “Communication.”