Planet Technology WGSW-2620P - Manual (Page 35)

Port 224.1.1.1 10 1,2,6
3.3.2.8 Mac / Filter Table Commands Set
Commands
Command
Level
Description Defaults Example
mac-address-table
aging-time [on | off]
mac-address-table
aging-time [sec.]
or no
mac-address-table
aging-time
Global
configuratio
n mode
Use the
mac-address-table
aging-time global
configuration
command to set
the length of time
that a dynamic
entry remains in
the MAC address
table after the
entry is used or
updated.
Use the no form of
this command to
use the default
aging-time
interval. The aging
time applies to all
VLANs.
300 secs
(Enable)
Switch (config)#
mac-address-table
aging-time on
Switch (config)#
mac-address-table
aging-time 333
(Disable)
Switch (config)#
mac-address-table
aging-time off
Or
Switch(config)# no
mac-address-table
aging-time
mac-address-table
table [static | filter]
hwaddr [MAC
address] vlanid
[VLAN-ID]
Interface
configuratio
n mode
Use the
mac-address-table
static to add static |
filter addresses to
the MAC address
table. Use the no
form of this
N/A
Switch (config)#
interface fastEthernet
0/2
Switch (config-if)#
mac-address-table
static hwaddr