2 port configuration, 3 trunk configuration – Planet Technology WGSW-2620P User Manual
Page 56
3.4.2 Port Configuration
You can set up every port status.
1. Select <Edit>
2. Use "Tab/Backspace" key to move between items.
3.
State:
Current port status. The port can be set to disable or enable mode. If the port setting is
disable then will not receive or transmit any packet.
4.
Negotiation:
set auto negotiation function of port.
5.
Speed/Duplex:
set the port link speed and duplex mode.
6.
FC:
enable or disable Flow control function (Flow control for full duplex link mode).
7.
BP:
enable or disable Back Pressure function (Backpressure for half duplex mode).
8.
Bandwidth In/ Out:
per port packet transmission rate control. Per level is 100Kbps. It supports
individual control method of TX and RX.
9.
Priority:
set packet of port to high or low priority queue.
10. Security: enable or disable port security function.
11. Select
the
<Apply>.
Port Configuration interface
3.4.3 Trunk Configuration
You can configure port trunk group.
1. Select
<Edit>
2. Using "Tab" key move to the port that want to be added as trunk group.
3. Using "Space" key to mark the port.
4. Using
Tab
key move to Trunk # (ex. Trunk1, Trunk2…) to change the Trunk # value to Static,
LACP
, or Disable.