Planet Technology WGSW-2620P - Manual (Page 38)

no port monitor Analyzer (SPAN)
port monitoring on
a port. Use the no
form of this
command to return
the port to its
default value.
monitor both 3
show port monitor
Interface
configuratio
n mode
Use the show port
monitor privileged
EXEC command
to display the ports
for which Switched
Port Analyzer
(SPAN) port
monitoring is
enabled.
Switch (config-if)# show
port monitor
State: ENABLE
AnalysisPortId: 8
Port 1 Rx: Monitor
Port 1 Rx: Monitor
Port 2 Rx:
Port 2 Rx:
Port 3 Rx: Monitor
Port 3 Rx: Monitor
Port 4 Rx:
Port 4 Rx:
Port 5 Rx:
Port 5 Rx:
Port 6 Rx:
Port 6 Rx:
Port 7 Rx:
Port 7 Rx:
Port 8 Rx: Analysis
Port 8 Tx: Analysis
Port 9 Rx:
Port 9 Rx: