Panasonic SX-KN2600 - Manual (Page 103)

Part IV Sequencer
103
QQTG0692
Se
qu
en
ce
r
ADVANCE/DELAY
Speed up or delay the sound production of spec-
ified performance data.
1. Use the TRACK
∧
and
∨
buttons to select the
track you wish to edit.
• You cannot select the track for the CONTROL,
RHYTHM or CHORD part.
• If ALL is selected, all tracks will be edited.
2. Use the FIRST MEAS
∧
and
∨
buttons to
specify the start point (measure number) of
the change.
3. Use the LAST MEAS
∧
and
∨
buttons to spec-
ify the end point (measure number) of the
change.
4. Use the ADVANCE/DELAY
∧
and
∨
buttons
to accelerate or delay the timing of the sound
production (–96 to +96).
• A + value causes the notes to sound later, and
a – value causes the notes to sound earlier.
5. Press the OK button.
• The confirmation display appears. Press the
YES button to execute the function, or press
the NO button to cancel the function.
SD Audio Synchro (KN2600)
The sound data on the SD card in the SD slot can be synchronized with SEQUENCER playback.
1. On the SEQ MENU display, press the SD
AUDIO SYNCHRO button.
2. Use the PLAYLIST NUMBER
∧
and
∨
buttons
to select the number you wish to synchronize
from the PLAYLIST.
3. Play back the SEQUENCER song. (Refer to
page 81.)
<Note>
When creating SEQUENCER data that is syn-
chronized with SD AUDIO data, the environment
in which the SD AUDIO data was created may
result in data that is slightly out of sync with the
SEQUENCER. When this occurs use the
TEMPO ADJUST feature to compensate for this
timing discrepancy (–127 to +127).
09_Part IV.fm 103 ページ ２００３年２月５日 水曜日 午後１時３４分