Panasonic SX-KN2600 - Manual (Page 164)

Part X Sound Edit
164
QQTG0692
So
un
d Edi
t
4. Use the CUTOFF
∧ and ∨
buttons to set the
frequency range which is cut by the filter.
5. Use the RESONANCE
∧ and ∨
buttons to
specify the resonance value (dB).
• Resonance is effect which adds character to
the sound by emphasizing the harmonic com-
ponents of frequencies close to the cut-off
frequency.
<Equalizer>
For LPF(6)
+EQ/HPF(6)+EQ filters, the sound
quality can be modified by the EQUALIZER.
RANGE
Select the setting range (HIGH or LOW).
FREQUENCY
Set the standard frequency.
GAIN
Set the level increase or decrease from the
value set for FREQ (dB).
6. Repeat steps 2 to 5 for each tone, as desired.
TOUCH & KEY FOLLOW
Adjust how the filter is applied relative to touch
and pitch.
1. Use the PAGE buttons to view the 2/4 display.
• The display looks similar to the following.
2. Use the buttons to the left of the display to
select a tone.
• Use the ▲ and ▼ buttons to select a setting
item and then the
∧ and ∨
buttons to specify a
selection.
3. Modify how the respective filters are applied
relative to key touch.
• Use the TOUCH CUT OFF
∧ and ∨
buttons to
specify the amount of change in the cut-off fre-
quency. Use the TOUCH CURVE
∧ and ∨
buttons to specify the curve of change. Use
the TOUCH RESONANCE
∧ and ∨
buttons to
specify the degree of change in the resonance
value.
4. Modify how the respective filters are applied
relative to note pitch.
• Use the KEY FOLLOW SLOPE
∧ and ∨
but-
tons to adjust the bend slope. Use the KEY
FOLLOW RANGE
∧ and ∨
buttons to specify
the pitch range.
5. Repeat steps 2 to 4 for the other tones, as
desired.
FILTER ENVELOPE
Specify how the filter changes over time, from
the time the key is played to the time the sound
dies out.
1. Use the PAGE buttons view the 3/4 display.
• The display looks similar to the following.
2. Use the buttons to the left of the display to
select a tone.
• Use the
▲ and ▼ buttons to select a setting
item and then the
∧ and ∨
buttons to specify a
selection.
3. Use the
∧ and ∨
buttons to modify the respec-
tive filter envelopes.
• Use the buttons below the display to adjust the
respective settings.
• You can use the CUTOFF ADJUST buttons to
set the total upper and lower settings, the
START POINT buttons to set the start point,
and the STOP POINT buttons to set the stop
point.
4. Repeat steps 2 and 3 for the other tones, as
desired.
15_Part X.fm 164 ページ ２００３年２月５日 水曜日 午後１時５５分