Panasonic SX-KN2600 - Manual (Page 108)

Part V Composer
108
QQTG0692
Co
m
p
os
e
r
Recording procedure
1. In the START RECORDING area on the dis-
play, select the rhythm part you want to record
first.
BAS: BASS
AC1–5: ACCOMP 1–5
DR1, 2: DRUMS 1, 2
• The metronome sound starts and the display
looks similar to the following.
2. Adjust the tempo.
• The tempo is shown on the display as
q
=.
• The tempo can be freely adjusted when you
play back the rhythm pattern, so record at the
tempo which is easiest for you to play.
3. Select the sound.
• For the DRUMS part, only sounds from the
DRUM KITS sound group can be selected.
• For the ACCOMP and BASS parts, select
sounds from groups other than the DIGITAL
DRAWBAR sound groups.
• The sounds marked with # represent special
guitar performances and changing them to
other sounds may result in an unnatural, awk-
ward sound expression.
4. Record the part.
• The specified number of measures are repeat-
edly played back, during which time any newly
played notes are added to those already
recorded. The current measure number is
shown on the display as “MEASURE=”.
• Record the performance in C major for correct
chord progressions during playback. Follow
the KEY SETTING procedure if you wish to
record the performance in a different scale.
• PITCH BEND, MODULATION (KN2600)
(except for the DRUMS part) effects are also
recorded.
• The SUSTAIN ON/OFF is also stored (except
for the DRUMS part).
ⅢⅢⅢⅢ Button functions
PART BALANCE:
Adjust the volume of each part on the PART
BALANCE display. (These settings are not
recorded.)
PART SETTING:
You can make detailed settings for each part.
(Refer to page 110.)
STEP RECORD:
Change to the STEP RECORD mode. (Refer
to page 111.)
SOLO:
Mute all parts except the part which is cur-
rently being recorded.
• A MUTE mark is shown for the other parts on
the display.
• To turn off the SOLO function, press this but-
ton again.
PART CLR:
Erase all recorded contents of the currently
selected part.
NOTE CLR:
Data is erased one note or one percussion
instrument (DRUMS part) sound at a time.
• Hold and press this button, and press the key-
board key that corresponds to the note or per-
cussion instrument (DRUMS part) sound you
wish to erase.
ALL ERAS:
The performance recorded in the selected part
is erased for as long as this button is pressed.
QUANTIZE:
Smooth out any unevenness in the timing of
your performance.
• Before recording, select the note value for the
desired quantize level. (The quantize level is
shown on the display as QUANTIZE=.)
10_Part V.fm 108 ページ ２００３年１月２７日 月曜日 午後１時４５分