Panasonic SX-KN2600 - Manual (Page 110)

Part V Composer
110
QQTG0692
Co
m
p
os
e
r
Part Setting
You can make detailed settings for each part.
1. On the REALTIME RECORDING display,
press the PART SETTING button.
• The settings comprise 3 pages of the display.
Use the PAGE buttons to switch pages.
2. Use the PART ▲ and ▼ buttons to select a
part.
3. Use the
∧
and
∨
buttons to set the corre-
sponding item.
<PAGE 1>
PITCH POINT:
The pitch at which the pattern progression
sound is lowered by one octave.
• When the root note of the specified chord is
higher than the set pitch point, the pitch of that
part is automatically lowered by one octave,
thus avoiding an unnaturally high accompani-
ment pitch.
• This is effective only for the part for which the
Melody group was selected in CHORD MOD-
IFY CHANGE.
SOUND:
Use the panel buttons to select the sound.
DIGI EFF:
Set the DIGITAL EFFECT to on or off.
• (SOUND) is the initialized setting of the sound.
<PAGE 2>
BALANCE:
Adjust the volume balance.
PAN:
Adjust the stereo balance of each part (LEFT
64 – CENTER – RIGHT 63).
• At “LEFT 64”, the sound is all the way to the
left, at “RIGHT 63” all the way to the right. The
center point is CENTER.
REV:
Depth of the REVERB (0 to 127).
CHO:
Depth of the CHORUS (0 to 127).
BEND RANGE:
Adjust the range of pitch change when the
PITCH BEND wheel is operated (0 to 12).
<PAGE 3>
EQ-Hi:
Sound correction in the high range.
• Use the FC
∧
and
∨
buttons to adjust the stan-
dard frequency. Use the GAIN
∧
and
∨
but-
tons to set the ratio of change.
EQ-Low:
Sound correction in the low range.
• Use the FC
∧
and
∨
buttons to adjust the stan-
dard frequency. Use the GAIN
∧
and
∨
but-
tons to set the ratio of change.
10_Part V.fm 110 ページ ２００３年１月２７日 月曜日 午後１時４５分