Panasonic SX-KN2600 - Manual (Page 112)

Part V Composer
112
QQTG0692
Co
m
p
os
e
r
5. Use the PHRS
∧
and
∨
buttons to specify the
actual length of the produced sound for the
desired legato or staccato effect.
6. Specify the pitch and velocity of the note by
playing the keyboard.
• The dot on the display where the note is
stored changes to a
∗
mark.
• When recording chords, you can store multiple
notes at one position.
REST: To store a rest, after specifying the note
LENGTH, press the REST button.
• Positions at which nothing is stored are read
as rests.
ERS: If you make a mistake, move the cursor to
the error, and after displaying the data
you wish to erase, press the ERS button.
7. Repeat steps 2 through 6 to continue storing
notes.
• To record a different part, use the PART
∧
and
∨
buttons to select another part.
• The NOTE, VELOCITY, LENGTH, CHORD
MODIFY and CONTROL can be revised later.
Press the OK button after the revision.
• You can easily switch between the REALTIME
mode and the STEP mode any time during
recording. To return to the realtime recording
display during the STEP RECORD mode,
press the EXIT button.
Measure Edit
You can edit the recorded data one measure at a time.
Select the function you wish to edit.
1. During recording, press the MEASURE EDIT
button.
• The display looks similar to the following.
2. Select the function.
3. Follow the procedure to edit the function (see
below).
• Only the contents of the same pattern can be
edited.
TENU (tenuto): Sound is produced for 95%
of the note length.
NORM (normal): 80%
STAC (staccato): 50%
CUTT (cutting):
25%
10_Part V.fm 112 ページ ２００３年１月２７日 月曜日 午後１時４５分