Panasonic SX-KN2600 - Manual (Page 161)

Part X Sound Edit
161
QQTG0692
So
un
d Edi
t
VELOCITY LAYER
Adjust these settings to regulate the tone output
relative to the velocity.
1. Use the PAGE buttons to view the 3/4 display.
• The display looks similar to the following.
2. Use the buttons to the left of the display to
select a tone (1st, 2nd, 3rd or 4th).
• Use the ▲ and ▼ buttons to select a setting
item and then the
∧ and ∨
buttons to specify a
selection.
3. Use the L-FADE
∧ and ∨
buttons and the
LOW
∧ and ∨
buttons to define the pp sound
output area for the lower range.
4. Use the HIGH
∧ and ∨
buttons and the H-
FADE
∧ and ∨
buttons to define the ff sound
output area for the higher range.
• By overlapping the L-FADE and H-FADE
curves of each different tone, you can change
the way the tone sounds relative to how hard
or softly the keyboard is played.
5. Repeat steps 2 to 4 for the other tones, as
desired.
TONE DYNAMICS
You can adjust the settings so that a different
sound (tone) is output for each tone depending
on the velocity (how hard the keys are played).
1. Use the PAGE buttons to view the 4/4 display.
• The display looks similar to the following.
2. Use the buttons to the left of the display to
select a tone.
3. Use the ▲ and ▼ buttons to select the col-
umn for the function you wish to adjust.
4. Select the tone waveform.
• Use the GR
∧ and ∨
buttons to select the
sound group. Use the TONE WAVEFORM
∧
and
∨
buttons to select the waveform.
5. Use the LEV
∧ and ∨
buttons to adjust the vol-
ume. Use the FLT
∧ and ∨
buttons to set the
sound.
6. Use the VELOCITY
∧ and ∨
buttons to specify
the velocity range.
• When the upper limit of a waveform is set to
127, no more waveforms can be added.
7. Repeat steps 3 to 6 to edit the other wave-
forms, as desired.
8. Repeat steps 2 to 7 for the other tones, as
desired.
15_Part X.fm 161 ページ ２００３年２月５日 水曜日 午後１時５５分