Panasonic SX-KN2600 - Manual (Page 166)

Part X Sound Edit
166
QQTG0692
So
un
d Edi
t
ENVELOPE
Specify how the volume changes over time, from
the time the key is played to the time the sound
dies out.
1. Use the PAGE buttons to view the 2/3 display.
• The display looks similar to the following.
2. Use the buttons to the left of the display to
select a tone.
• Use the
▲ and ▼ buttons to select a setting
item and then the
∧ and ∨
buttons to specify a
selection.
3. Adjust the settings for the volume envelope.
• Use the buttons below the display to set the
corresponding values. The envelope is cre-
ated on the display as you input the settings.
• Use the SUSTAIN PEDAL
∧ and ∨
buttons to
select the type of sustain.
LONG:
Extend the release time of the sound.
HOLD:
Maintain the key-pressed condition.
4. Repeat steps 2 and 3 for the other tones, as
desired.
ENVELOPE TOUCH & KEY FOLLOW
Specify how the volume changes relative to
touch or note pitch over time.
1. Use the PAGE buttons to view the 3/3 display.
2. Use the buttons to the left of the display to
select a tone.
• Use the ▲ and ▼ buttons to select a setting
item and then the
∧ and ∨
buttons to specify a
selection.
3. Change the touch settings.
• Use the TOUCH ATTACK
∧ and ∨
buttons to
specify the ATTACK time change depending
on touch. Use the TOUCH DECAY
∧ and ∨
buttons to specify the DECAY time change
depending on touch.
• At a − setting, the softer the keys are pressed,
the greater the change. At a + setting, the
harder the keys are pressed, the greater the
change.
4. Change the key follow settings for the
ATTACK, DECAY and RELEASE.
• Use the RANGE buttons to specify the key-
board range.
15_Part X.fm 166 ページ ２００３年２月５日 水曜日 午後１時５５分