Panasonic SX-KN2600 - Manual (Page 135)

Part VII SD Card (KN2600)
135
QQTG0692
S
D
C
a
rd
(
K
N
2
600
)
ⅢⅢⅢⅢ
COMPOSER LOAD
Load COMPOSER data only from a card.
1. In the RHYTHM GROUP section, press and
hold the LOAD (MEMORY) button for a few
seconds.
• The display looks similar to the following.
2. Use the buttons below the display to select the
SONG you wish to load.
• Select the folder name first, and then select
the SONG name.
• Press the PREV button for the previous page
and the NEXT button for the next page.
3. Press the LOAD button.
• Data is loaded to this instrument’s COM-
POSER memory (MEMORY).
SD-SOUND LOAD (SMF)
Load SD-SOUND (SMF) data from the SD card.
1. On the LOAD (PAGE 1/3) display, press the
SD-SOUND button.
• The display looks similar to the following.
• For cards which contain SD-SOUND data
only, this display appears automatically when
LOAD is selected on the SD MENU display.
2. Use the buttons below the display to select the
SONG name you wish to load.
• Use the PLAYLIST button to specify the
PLAYLIST (see page 138), the SONG
SELECT button to specify the SONG.
• If you press the PLAYLIST EDIT button, the
display changes to the PLAYLIST EDIT dis-
play. (See page 138.)If you press the TECH
button, the display changes to the LOAD dis-
play for the TECHNICS SONG.
3. Use the TO SONG button to select the num-
ber to load to (this instrument’s SEQUENCER
song number).
• Songs to load are specified one at a time.
• The SEQUENCER song name to load to is
shown below the TO SONG button.
4. Use the LOAD AS button to specify the load
method.
• Select from the following.
GM/GM2 → GM2:
Activate the GM2 initialized settings, and
load GM/GM2 data.
NX → NX:
Active the NX SOUND settings, and load
NX data.
GM/GM2 → NX:
Activate the NX SOUND initialized settings,
and load GM/GM2 data.
PREV. TEC → NX:
Activate the NX SOUND initialized settings,
and load SMF data that was saved in the
TECHNICS mode on a previous model.
(The volume balance and octave settings
may differ from the saved settings.)
• If you select the setting which is different from
that in which the song was stored, the sounds,
octaves, and arrangement of percussion
instrument sounds, etc. will be different.
5. Press the LOAD button.
• The LOAD operation begins.
• When the operation has been successfully
completed, “COMPLETED!” is shown on the
display.
• If you press the START/STOP button, play-
back of the loaded data begins.
• During the LOAD operation, data that cannot
be processed by this instrument is ignored.
RHYTHM GROUP
POP ROCK DANCE POP BALLAD
SIMPLE
BEAT
DANCE
CLUB
TRAD &
WALTZ USA
JAZZ &
SWING BALLROOM
& SHOW
LATIN &
WORLD
MEMORY
LOAD
12_Part VII.fm 135 ページ ２００３年３月９日 日曜日 午後３時５分