NEC NX7700i/5040H-32 - Manual (Page 116)

Base Module
855-900547-200 2-80
Category Configuration Parameter Default Setting
Hot Plug
permission
[Hot Plug permission]
Specifies whether Hot-Plug is enabled or not, for
each of the target components.
Target components: CELL, PCIDBAY, PCIEBAY,
PCI(X) card, and PCI-Ex card
The 8Way model has no PCIDBAY or PCIEBAY
settings.
The 32Way(H) and ISPF require PCI(X) card and
PCI-Ex card settings.
off
SP LAN/Serial Port Setting:
Category Configuration Parameter Default Setting
The following parameter settings are needed
depending on the other device (terminal
emulator) to which the SP is connected as a
local console.
-
Baud rate 9600
Data bit width is only listed.
It is unable to be changed.
8
Stop bit width is only listed.
It is unable to be changed.
1
Parity is only listed.
It is unable to be changed.
None
Serial port
Flow control is only listed.
It is unable to be changed.
RTS/CTS
IP address for LAN0
192.168.119.100
or
192.168.119.101
Subnet mask 255.255.255.0
LAN0
Gateway IP address N/A
IP address for LAN1. LAN1’s subnet must be
different from LAN0’s subnet.
192.168.119.200
Subnet mask 255.255.255.0
LAN1
[ISPF only]
Gateway IP address N/A
LAN/Seri
al
NTP server
NTP server’s IP address.
If the server IP address is set, iSP’s internal
clock is corrected every 1 hour.
If the IP address is omitted, the iSP clocks on its
own.
N/A
System number
(*3)
[ISPF only]
[Self SYSTEM NUMBER]
System number (0 or 1).
It is used as part of cabinet location numbers.
Different system numbers must be set for the 2
cabinets that constitute a cluster.
0
Cabinet
clustering (*3)
[ISPF only]
Specifies whether cabinet clustering is used or
not.
no
ISPF Clus
ter
Cabinet-clustered
SP
LAN0/1 (*3)
[ISPF only]
For cabinet clustering, the other iSP’s IP
address is specified. LAN1’s subnet must be
different from LAN0’s subnet.
LAN0:
192.168.119.110
LAN1:
192.168.119.210
(*3): If any of these configuration parameters has been changed, reset the SP in ISPF System
2.