NEC NX7700i/5040H-32 - Manual (Page 75)

Base Module
855-900547-200 2-39
2.4.6.3. DP (System Dump)
m b u
X
* The command is executable to the active partition (after automatic system boot/UP
command execution).
Function:
This command causes a Dump interrupt to the system after a system dump is taken.
Whether a system dump is actually taken or not, or a system reset is subsequently activated or
not, depends on the system software (OS or BIOS). This command only causes a Dump
interrupt.
Nothing will happen, of course, if the software is not running.
(Screen Example)
Description
No.
iSPyz:---> dp <ENTER>
Dump button interrupt will be generated.
Enter partition number (0-7/all/CR=exit) : all <ENTER> (a)
Execute OK? (y/[n]) y <ENTER> (b)
DP command was accepted. Dump button interrupt will be generated soon. (c)
[iSPyz:INFO.ccc] partition 0 : dump button interrupt.
[iSPyz:INFO.ccc] partition 1 : dump button interrupt.
:
:
:
(d)
(Description)
Description
No.
Description
(a)
Enter the target partition number here.
If “all” is specified, all the existing partitions are the target of this command.
(b)
A confirmation message appears.
If you are sure to continue command execution, enter “y.”
(c)
A “DP command accepted” message appears.
Actual processing progresses in the background.
(d) Shows progress in the background.