NEC NX7700i/5040H-32 - Manual (Page 85)

Base Module
855-900547-200 2-49
cmd arg1 arg2 arg3 arg4 Description
mmxxy - - - Show the detailed configuration of the ROW
under the MMX specified by xy, and in the
case of the 32Way(H) model, show detailed
configuration of the DIR.
x is the physical CELL number where the
MMX is installed (0-7).
y is the MMX number within the CELL (0-3).
tagxs - - - Show the detailed configuration of the TAG
for the 32Way(B)/8Way/ISPF models. This
argument is invalid for the 32Way(H) model.
x is the physical CELL number where the
TAG is installed (0-7).
s is either ’e’ (EVEN side) or ’o’ (ODD side).
xbxcx - - - Show the XBX Card configuration and XBX
LSI configuration on that card.
x is a physical XBX Card number (0-3).
xbxxy - - - Show the XBX configuration.
x is an XBX Card number (0-3).
y specifies an XBX number on the XBX Card
(0-1).
pcibx
ioxx - - - Show the PCI Bay (IOX) configuration.
x is the DGI/I2C cable port number (0-7) that
connects iSP to PCI Bay.
pcix - - - Show the configurations and information of
the PCI Cards that are under the PXH within
the PCI Bay.
x is the DGI/I2C cable port number (0-7) that
connects iSP to PCI Bay.
cpcix - - - Show the configurations and information of
the PCI Cards on the Core Card within the
PCI Bay.
x is the DGI/I2C cable port number (0-7) that
connects iSP to PCI Bay.
pbayx - - - Show the Power Bay configuration.
x is a Power Bay number. The allowable
range of x is as follows:
For 32Way:
0, 1: Power Bay numbers within the Main
Cabinet
2, 3: Power Bay numbers within the
Expansion Cabinet
For 8Way:
0: Power Bay No. inside the chassis
1: Power Bay No. outside the chassis
For ISPF:
0: Power Bay No. inside the chassis
attach - - - - Use this command to attach partition
numbers to CELL or IOX Cards.
If no argument is specified or an argument
has an error, the attach command help
opens.
This command is not valid while the partition
is booting up, shutting down, or handling an
error.