Oki 5700 - Manual (Page 52)

English
4-4 Chapter 4
3 Press ENTER to select SPEED DIAL.
4 Input Speed Dial number to be programmed (one-touch, 2-digit, 3-
digit), press ENTER.
5 Input LOC # (telephone number), press ENTER.
6 Input Name, press ENTER.
7 Input ALT# (telephone number), press ENTER.
8 Press
↑
or
↓
to select Communication Speed, press ENTER.
9 Press
↑
or
↓
to select Echo Protection, press ENTER.
10 Press
↑
or
↓
keys to select mode (G4 or G3), press ENTER.*
This step required only if ISDN G4 board is installed. However, this
setting is specific to each Speed Dial number and is not affected by the
overall machine ISDN setting (speed access no. 27).
11 Repeat the above process from Step 3 until finished programming.
When finished, press MENU/EXIT to return the machine to standby
mode.
12 When finished with the programming of one-touch keys, lift the plastic
cover protecting the one-touch labels and (using a pencil) write the
names corresponding to the newly programmed keys on their
respective labels. Then replace the cover.
Notes:
1 When entering a new telephone number using the numeric
keypad, it is possible to register it to a Speed Dial number. After
entering the telephone number, press the SEARCH key. The
location of unregistered Speed Dial numbers will be displayed.
2 Switch the Echo Protection setting to OFF when changing the
location of a One-Touch key.
Chain Dialling
Even though the telephone number for each One-Touch key can be up to
40 digits long, there may be a need to dial numbers with more digits. This
function is provided for that purpose. To create a chain dial number,
program the first 39 digits into a Speed Dial number, press the Plus (+) key
(One-Touch key #39), and then program the rest of the number as if
programming another Speed Dial entry.