Oki 5700 - Manual (Page 60)

English
4-12 Chapter 4
5 Data in memory will be printed out.
* Password is only required when previously programmed and
machine answering mode is set to MEM (see Memory Password).
No Paper Reception
If the machine runs out of paper when receiving a fax, a message will be
displayed and the data not yet printed stored in memory automatically for
printing out later. (The machine will print the data stored in memory
automatically after paper is added to the paper tray.)
No Toner Reception
If the machine is running low on toner, and NO TONER MEMORY
RECEIVE is set to ON, a message will be displayed and incoming faxes
stored in memory automatically for printing later (rather than risk printing
illegible messages). If the machine receives a message to memory because
the toner level is low, “Message in memory” will be displayed.
When NO TONER MEMORY RECEIVE is set to OFF, a warning
message will be displayed.
Note:
When the “Toner low” message is shown, it is possible to use the
print from memory function to print the faxes stored in memory, but
the quality of the print cannot be guaranteed. Replace the toner
cartridge as soon as possible.
Cancelling Messages Stored in Memory
It is possible to erase messages stored in memory without printing them.
1 Follow the same instructions as for Print from Memory.
2 When prompted to print the message, press the STOP key.
3 When prompted to cancel the message, press ENTER key.
Unsolicited Fax Rejection
The machine provides a closed network option that allows the refusal of
unsolicited faxes. If activated, when there is an incoming call the machine
will compare the TSI (CIG) with the last four digits of the programmed
Speed Dial numbers. If there is no match, the incoming call will be refused
automatically, thus eliminating unsolicited faxes such as advertising. The
machine can also be set to neither send nor receive faxes from locations
whose telephone numbers are not programmed into the Speed Dial