Installing, Installing the monitor(s), Installing the camera – Tandberg Data 7000 User Manual
Page 15: Tandberg videoconferencing system, Installation
TANDBERG Videoconferencing System
15
Installation
T
HE
CAMERA
SHOULD
BE
ALIGNED
WITH
THE
FRONT
EDGE
OF
THE
MONITOR
TO
ENSURE
THE
IR-
SENSOR
IN
THE
CAMERA
CAN
PICK
UP
SIGNALS
FROM
THE
REMOTE
CONTROL
.
Installing
Installing the monitor(s)
We recommend that there are 3 people present when installing the monitor(s).
•Remove the plastic plugs located on the back of the monitor(s). Check to see where the holes in the Monitor
Rack are located.
•Take the monitor(s) and place it (them) inside the Monitor Rack.
•Secure each monitor with the 8mm hexagonal-shaped screws.
•Remove the protective plastic film from the monitor front.
Installing the camera
Take the camera and remove the plastic backing from the double-sided pads on the base of the unit. Place the
camera centrally on top of the monitor, in line with the front of the screen.
R
EMEMBER
THAT
THERE
SHOULD
BE
A
GAP
ON
EACH
SIDE
OF
THE
MONITOR
.
B
E
CAREFUL
WHEN
REMOVING
THE
PLASTIC
FILM
. DO NOT
PULL
THE
PLASTIC
OFF
THE
MONITOR
AT
A
90º
ANGLE
AS
THIS
MAY
DAMAGE
THE
SCREEN
. I
NSTEAD
YOU
SHOULD
REMOVE
THE
PLASTIC
FILM
BY
PULLING
IT
PARALLEL
WITH
THE
SCREEN
AT
A
180º
ANGLE
.
NOTE
NOTE
NOTE