Tandberg Data 7000 - Manual (Page 56)

56
TANDBERG Videoconferencing System Advanced use
Request floor
When requesting the floor, the MCU will broadcast your video in full screen to all other participants in the
conference. If the MCU conference has a chairman, a floor request is sent to the chairman.
You will remain ‘On Air’ until either you select ‘Release Floor’ or the chairman decides to release the floor to
another participant.
Release floor
You choose ‘Release Floor’ to take you ‘Off Air’. You should do this when you wish to make the floor available to
the other participants in the conference.
Terminal Names
Allows you to see the site numbers or name (if supported) of other sites connected in the conference.
View site # *
Allows you to view any participant in the conference other than the participant currently ‘On Air’.
End view
Allows you to stop viewing the site previously chosen with ‘View Site #’, and returns your view to the site that is
currently ‘On Air’.
‘V IEW S ITE ’ AND ‘E ND V IEW ’ CAN BE USED BY ALL CONFERENCE PARTICIPANTS .
* - NOT supported by the MultiSite
TIP