Monitor configuration, Securing the cables, Attaching the back covers – Tandberg Data 7000 User Manual
Page 17: Lan cable
Advertising
TANDBERG Videoconferencing System
17
Installation
Monitor configuration
Power up the codec and the monitors. Use the monitor remote control to set the monitors to Y/C.
Securing the cables
It is important that the wires are secured inside the base so that they don’t get in the way of the covers, which are
to be screwed on to the back.
Attaching the back covers
Screw the two back covers on to the base. The lower of the two covers should be attached first.
A
TTACH
THE
POUCH
FOR
THE
REMOTE
CONTROL
TO
THE
BACK
OF
ONE
OF
THE
MONITORS
. T
HE
REMOTE
CONTROL
CAN
THEN
BE
STORED
IN
THIS
POUCH
.
6. LAN cable
• To use the system on LAN, connect a LAN cable from the ‘Ethernet’ connector on the system to your LAN.
TIP
Advertising