Tandberg Data 7000 - Manual (Page 70)

70
TANDBERG Videoconferencing System Advanced use
If you want to use your system via ISDN-PRI, you should select ‘Current Network: ISDN-PRI’ and enter the
‘ISDN-PRI Settings’ menu to set the PRI parameters.
If you want to use your system via Leased E1/T1, you should select ‘Current Network: Leased E1/T1’ and enter
the ‘Leased E1/T1 Settings’ menu to set the Leased E1/T1 parameters.
B OTH ‘L EASED E1/T1’ AND ‘ISDN-PRI’ USES THE SAME PHYSICAL INTERFACE ON THE CODEC MARKED ‘E1/T1’.
If you want to use special networks and connect using RS449, V.35, X.21 or connect to ISDN via an external
IMUX you should select ‘Current Network: External’ and enter the ‘External Network Settings’ menu to set
the External Network parameters.
NOTE