Audio outputs – Tandberg Data 7000 User Manual
Page 60
60
TANDBERG Videoconferencing System
Advanced use
Audio Outputs
Audio out 1 is intended for connection to TANDBERG Natural Audio, televisions or audio amplifiers.
Audio out 2 is intended for connection to audio recording equipment or to a telephone add-on hybrid. The signal is
a mix of audio from both the far end and local end (not from Audio in 5).
Audio out 3 is intended for connection to a VCR or other recording equipment. The signal is a mix of audio from
far end and local end (not from Audio in 6).
Audio Module: Select Natural Audio Module according to the type of Audio Module installed.
N
EVER
CONNECT
AUDIO
OUT
2
OR
AUDIO
OUT
3
TO
A
LOUDSPEAKER
PLACED
IN
THE
SAME
ROOM
AS
THE
MICROPHONES
CONNECTED
TO
THE
SYSTEM
. D
OING
THIS
WILL
CAUSE
“
HOWLING
”
AND
POSSIBLE
DAMAGE
TO
THE
SPEAKER
SYSTEM
.
If an output is ‘Off’, no audio will be sent to that output.
Level Settings - Outputs
Adjust the audio output levels according to the parameters of the external audio equipment connected. These
levels should only be adjusted when installing new audio equipment. The default settings are correct for the
TANDBERG Natural Audio module and for most consumer electronics devices (televisions, VCRs, etc.).
The volume keys on the remote control adjust the level of output 1 (the speaker output). The volume control has
no effect on outputs 2 and 3.
NOTE