Connecting cables – Tandberg Data 7000 User Manual
Page 16
16
TANDBERG Videoconferencing System
Installation
Connecting cables
All cables needed in standard configuration are connected to the codec. Connect these cables to the other parts
of the system:
1. Power cable
Connect the system power cable to an electrical distribution socket.
2. Monitor cables
Connect the 2 BNC (Y/C input at the monitor), the 9 pin DSUB and the power cable to the input on your monitor.
You will find the cables coiled up in the base (for dual monitor systems there will be a coil for each monitor).
3. Microphone cable
Connect the microphone cable to the microphone.
4. Camera cable
Connect the camera and the camera cable.
5a. ISDN cables - using BRI interface
Connect the ISDN cables to the ISDN sockets (S/T-interface) provided by the service provider. Your main number
will be the number associated with the socket to which ISDN cable number 1 is connected.
T
HE
SYSTEM
DOES
NOT
HAVE
A
BUILT
-
IN
NETWORK
TERMINATOR
. I
F
YOUR
WALL
SOCKET
PROVIDES
YOU
WITH
AN
ISDN U-
INTERFACE
,
YOU
WILL
NEED
AN
NT1
BETWEEN
YOUR
SYSTEM
AND
YOUR
ISDN
LINE
,
SEE
A
PPENDIX
1.
5b. ISDN cable - using the PRI interface
If you are using the PRI interface, the E1/T1 cable should be connected to a CSU (Channel Service Unit). You will
need a CSU between your system and the PRI line from your network provider, see Appendix 3.
5c. Other networks - using the External Network interface
If you are using other networks, please refer to ‘External Network Settings’ and ‘Appendix 2’.
NOTE