Tandberg Data 7000 - Manual (Page 91)

TANDBERG Videoconferencing System
91
Advanced use
Dataport configuration
The system provides two standard RS 232 serial ports to allow a computer to be connected for data transfer and
control purposes.
W
HEN CONNECTING TO A
PC
THE CONNECTING CABLE MUST BE A STRAIGHT THROUGH
RS232
CABLE
.
Dataport 1
If you wish to connect a PC to Dataport 1, you must ensure that the PC and the system are identically
configured. The available settings are:
Dataport 1 supports 4 different modes:
Data mode
Provides a transparent data channel. This channel can be used
for many different purposes such as file transfer, application
sharing and more. When using this mode, it is necessary to
have a TANDBERG system at the far end.
Control mode
The control interface provided by the Dataport supports a subset
of the Hayes command set as well as a comprehensive set of
system specific commands.
This mode maintains communication with the Dataport’s
command interpreter at all times. All features available from the
hand-held remote control can be accessed through the dataport.
This menu consists of 6 network profiles, a prefix can be added for each profile. If you add a prefix to a profile, this
prefix can be automatically added to the number being dialed.
E XAMPLE :
0 IS ADDED AS A C ALL P REFIX TO THE 2 ND PROFILE , ISDN. I F YOU ENTER 12345678 IN THE DIAL MENU AND SELECT ‘ISDN’, THE NUMBER
DIALED WILL BE 012345678.
Using the three last profiles you can enter the name of a profile, prefix and network selection. This is useful if you
have a fixed prefix for your service provider.
TIP
NOTE