Tandberg Data 7000 - Manual (Page 19)

TANDBERG Videoconferencing System
19
Installation
ISDN configuration
For each installation of the system it is necessary to configure the unit. All configuration parameters are available
via the menu system. If you are using an external IMUX or special networks, the external equipment may also
need to be configured.
• Press M ENU on the remote control. Select the menu ‘Terminal Settings’, then ‘Network’.
Set ‘Current Network’ to the network you want to use.
Specify the settings for the selected network in one of the menus.
For details, follow the instructions in chapter ‘Terminal Settings’, ‘Network Configuration’ in this manual.
For further information refer to the examples in:
Appendix 1: Connecting the system to ISDN using NT1 network adapters
Appendix 2: Connecting the system to the Switched 56 network