Next 10 button – Telex IP-223 User Manual
Page 105
107
Crosspatch Setup Window
Next 10 Button
The Next 10 button is used to traverse the window between crosspatch entries 1 and 100.
To define the crosspatch parameters, do the following:
1.
From the links, select Crosspatch Setup.
The Crosspatch Setup window appears.
2.
Select the Line-Line Enable check box to route audio from one line to another line.
3.
From the Start Patch FTone drop down menu, select the function tone that starts a crosspatch between two radios.
4.
From the Stop Patch FTone drop down menu, select the function tone that stops a crosspatch between two radios.
5.
Select the RCP Enable check box to enable RCP.
6.
In the Dialing Digits field, enter the number of DTMF digits allowed in the Drop All, Add String, and Delete Strings
fields on the window.
7.
In the Interdigit Time field, enter the amount of time (in ms) allowed between DTMF digits before a reset occurs.
8.
In the Beep Dly field, enter the amount of time (in ms) between digit string detection and status beeps echoed back.
9.
In the Patch Timeout field, enter the amount of time (in seconds) allowed for inactivity on an active patch before the
patch is dropped.
10.
In the Global field, enter the amount of time (in seconds) allowed for inactivity on all patches before all patches are
dropped.
11.
In the Drop All field, enter the DTMF digit sequence to drop all current patches.
NOTE: The DTMF digit sequence entered must be the number of digits specified in the Dialing Digits field in step 6.
12.
Complete Entry 1 in the RCP Tables, if applicable:
13.
In the Add String field, enter the DTMF digit sequence to add this crosspatch entry.
NOTE: The DTMF digit sequence entered must be the number of digits specified in the Dialing Digits field in step 6.
14.
In the Delete String field, enter the DTMF digit sequence to delete this crosspatch entry.
NOTE: The DTMF digit sequence entered must be the number of digits specified in the Dialing Digits field in step 6.
15.
From the Mode drop down menu, select the desired crosspatch mode.
16.
In the Phone field, enter the phone number of the phone to be dialed.
17.
From the #1 or #2 drop down menu, select the applicable DB25 connector port used on the remote IP-223.
18.
In the IP Address field, enter the IP Address of the remote IP-223 with the radio used in this crosspatch entry.
19.
In the Rx Multicast field, enter the Multicast Address for the RX audio traffic.
20.
In the Rx Port field, enter a unique RX port number.
21.
In the Tx Multicast field, enter the Multicast Address for the TX audio traffic.
22.
In the Tx Port field, enter a unique TX port number.
23.
When all entries in the RCP Table are complete for entry 1, repeat steps 13 through 22 above to complete the
required remote crosspatch entries on this window.
24.
If all of the remote crosspatch entries are complete on the window and more crosspatches need to be defined, click
Submit.
The entries currently displayed on the window are sent to the IP-223 for storage.
OR
If all of the remote crosspatch entries are complete on the window and no more crosspatches need to be defined, click
Submit.
AND
proceed to step 28.
The entries currently displayed on the window are sent to the IP-223 for storage.