Telex IP-223 - Manual (Page 77)

79
Per Line Setup Window—iDEN Radio Configuration
Jump To Entry Drop Down Menu
The Jump To Entry drop down menu allows you to select (in groups of 10) function tones to view and modify.
1. From the Jump To drop down menu, select the group of 10 function tones you want to view.
2. Click Update.
The function tones you select appear.
Update Button
The Update button searches and displays the selection you chose from the Jump To drop down list.
Tone Enable Check Box
The Tone Enable check box indicates whether or not the function tone is active. If selected, the function tone is active. The
frequency for the tone is set on the Tone Frequency and Durations window described on page 114. The standard function tones
and their frequencies are the default entries. These entries are shown in Table 7 on page 114.
NOTE: At least one function tone must be selected.
Relay Drop Down Menu
The Relay drop down menu, shown in Figure 112, identifies the relay(s), if any, closed immediately upon receipt of the
function tone.
Available selections for this field are: no selection, R01, R02, or BOTH.
Function Tone Setup
FIGURE 112. Relay Drop Down Menu-Per Line Setup