Chapter 4 setup information, Setting the ip address information, Setup information – Telex IP-223 User Manual
Page 31
33
CHAPTER 4
Setup Information
The setup information for the IP-223 is accessed by using a web browser, such as Microsoft
®
Internet Explorer. This section
describes the programming information for the IP-223. It includes information on setting the IP Address, accessing the IP-223
web setup windows, the setup window standards, and an explanation of the fields on each window used to program the IP-223.
Setting the IP Address Information
Before entering the setup information for the IP-223, the IP Address and Network Mask must be assigned to the IP-223 by
the use of a web browser or Windows™ HyperTerminal™ if the assigned IP Address is not accessible on your network.
Contact your network administrator to obtain the network IP Address and Mask.
For the IP-223 to interface successfully with the LAN or WAN, the IP Addresses of the IP-223 and your PC must be on the
same subnet. IP Addresses consist of four numbers separated by periods. For example, 10.2.99.101. For more information on
IP Addresses and subnets, consult your network administrator.
In order for the PC and the IP-223 unit to communicate via IP, both devices need to be in the same subnet.
NOTE:
For operation on different subnets, a gateway address must be configured.
An example of IP Addresses residing in the same subnet:
PC IP Address:10.2.99.250
IP-223 IP Address:10.2.99.251
IP-223 Network Mask:255.255.255.0
To display the IP Address and Network Mask assigned to the IP-223, do the following:
1.
Connect power to the IP-223.
The IP Address and subnet mask are displayed on the LCD momentarily upon power up.
2.
To check the IP Address and subnet mask at any other time, press and hold the line button on the front panel of the
IP-223, and then momentarily press the IC button.
The IP Address is displayed on the top line of the LCD, and the Network Mask is displayed on the bottom line of the
LCD.
Verify the IP Address and Network Mask obtained from your network administrator to the IP-223 addresses.
If the IP Address and Network Mask need to be set up using the serial port, see “Using HyperTerminal” below.