Telex IP-223 - Manual (Page 88)

Setup Information
90
Save to EEPROM Window
The Save to EEPROM window is used to save the current configuration to the IP-223 or to reset the parameters on the
configuration webpage to the last configuration saved to the IP-223.
NAVIGATION: Clicking Save to EEPROM displays the Save Parameters and Reset IP-223 command buttons, shown in
Figure 119
Save Parameters Button
The Save Parameters button is used to save any changes submitted to the IP-223 for storage into permanent memory.
Reset IP-223 Button
The Reset IP-223 button is used to perform a full reset of the IP-223. This is the software version of a power down reset.
To save changes to permanent memory, do the following:
1. From the links, select Save to EEPROM.
The Save Setup Parameters window appears.
2. Click Save Parameters.
The parameters are saved to permanent memory.
NOTE: If the Submit button on an individual setup window was not selected before moving to another window, any
changes made to the entries on the window are not saved to permanent memory even when the Save Parameters
Button is selected.
To reset the IP-223, do the following:
1. From the links, select Save to EEPROM.
The Save Setup Parameters window appears.
2. Click Reset IP-223.
A momentary loss of connectivity occurs and the window shown in Figure 120 appears. The connection is restored
after several seconds.
3. Click a link to access a setup window, otherwise close the web browser.
FIGURE 119. Save to EEPROM