Telex IP-223 - Manual (Page 61)

63
Per Line Setup Window—Local, Tone, and Console Mode Configuration
2-Wire Check Box
The 2-Wire check box indicates whether or not the line number to which the details on the window apply is configured as
2-wire. If selected, the line number to which the details on the window apply is configured as a 2-wire line.
Parallel Console Check Box
The Parallel Console check box indicates whether or not a parallel console is being used (for example, a legacy tone console,
only available in console and tone mode). If selected, a parallel console is attached to the system.
NOTE: Must be enabled when console is configured for EIA.
NOTE: Must be enabled when configuring for Console Mode.
PTT Notch Filter Check Box
The PTT Notch Filter checkbox, when selected, indicates the 2175Hz notch filter is enabled. When selected, 2175Hz ±180Hz
frequency range is filtered during PTT. Use this option when 2175Hz is blocking desirable audio.
The PTT Setup section allows a secondary external function to be controlled with a separate relay closure at the same time as
the PTT relay. Select one of the following:
PTT relay only – When selected, only the PTT relay is closed. (Default Setting)
PTT + R1 – When selected, both the PTT relay and the R1 relay close at the same time.
PTT + R2 – When selected, both the PTT relay and the R2 relay close at the same time.
PTT + BOTH – When selected, the PTT relay, the R1 relay, and the R2 relay close at the same time.
PTT Timeout Field
The PTT Timeout field is used to indicate how long, in seconds, to allow PTT to be active when no audio is transmitted. If a
time is entered in the field, PTT activity will timeout after the designated amount of time has lapsed. This feature is useful in
cases where the line goes offhook for an indefinite period of time due to a stuck PTT key.
The range for this field is 0 to 1800sec. To disable this feature, enter zero (0).
Serial Port Mode Drop Down Menu
The Serial Port Mode drop down menu, shown in Figure 100, is used to identify the specific radio interface for the serial port
configuration. Selecting an item with a Scan List suffix enables a frequency scan list update function. The freq scan list
function synchronizes the console scan list with the radio's scan list.
By default, the serial port in Tone or Console mode is Normal.
PTT Setup
Serial Port Mode