Created accounts – Telex IP-223 User Manual
Page 91
93
Account Setup Window
Confirm Password Field
The Confirm Password field is used to confirm the password you entered in the New Password field. This password must
match the password entered in the New Password field.
Edit Button
The Edit button is used to make changes to the user system account password. The edit button is inactive until the user account
is enabled.
To enable the user account, do the following:
1.
Select the enable check box next to the account,
2.
Click Submit.
The edit button becomes active.
NOTE: The only configurable fields are the New Password field and the Confirm Password field. Also, when the
Edit window is open, a Set No Password check box appears. For more information, see “Edit System
Accounts Window” on page 94.
Save Button
The Save button is used to temporarily save the change you have made to the system account. You must click the Submit
button to save the change made to the console.
Remember, you must Submit the changes to the console, too. The data is not stored in permanent memory until it is saved, as
explained in “Save Parameters Button” on page 90.
Submit Button
The Submit button, located at the bottom of each configuration window, is used to upload changes to the IP-223. The submit
button saves changes in temporary memory only.
To permanently save changes, do the following:
1.
Click Submit.
The changes are sent to the IP-223 in temporary storage.
2.
Click Save to EEPROM.
The Save to EEPROM window opens.
3.
Click Save Parameters.
Changes are now permanently saved to the IP-223 console
Delete, Username, Password, New Password, Confirm Password Display Columns
The Delete, Username, Password, New Password, Confirm Password display columns display the existing user accounts
(up to 5) you have created.
NOTE:
Under the Delete column, a check box is shown. If the check box is selected, the account is marked for
deletion.Click the Delete button to delete the user account. The deletion is not complete until it is saved, as
explained in “Save Parameters Button” on page 90.
Created Accounts