Telex IP-223 - Manual (Page 108)

Setup Information
110
To permanently save changes, do the following:
1. Click Submit.
The changes are sent to the IP-223 in temporary storage.
2. Click Save to EEPROM.
The Save to EEPROM window opens.
3. Click Save Parameters.
Changes are now permanently saved to the IP-223 console.
Prev 30 Entries Button
The Prev 30 Entries button is used to traverse the window between crosspatch PIN entries 1 and 300.
Next 30 Entries Button
The Next 30 Entries button is used to traverse the window between crosspatch PIN entries 1 and 300.
To define crosspatch PIN numbers, do the following:
1. From the links, select CRP PIN Table.
The Remote CrossPatch Pin Setup window appears.
2. Select the PIN Enable check box if a PIN number is required to create a crosspatch.
3. In the PIN field, enter a PIN number for the crosspatch number.
4. Continue entering a four digit PIN number for the crosspatch numbers until all required PIN entries are complete on
the window.
5. If all of the PIN entries are complete on the window and more PINs need to be defined, click Submit.
The entries currently displayed on the window are sent to the IP-223 for storage.
OR
If all required Crosspatch PIN entries are complete on the window and no more PINs need to be defined, click
Submit
AND
proceed to step 9.
The entries currently displayed on the window are sent to the IP-223 for storage.
6. Click the Next 30 button to move to the next Remote CrossPatch Pin Setup window.
7. Repeat the steps 3 though 5 above to continue entering the Crosspatch PIN entries until all of the required PIN
entries have been completed.
8. After all PINs have been entered, click Submit.
The entries currently displayed on the window are sent to the IP-223 for storage.
9. From the links, select Save to EEPROM.
The Save Setup Parameters window appears.
10. Click Save Parameters.
The entries are saved to permanent memory.