Telex IP-223 - Manual (Page 82)

Setup Information
84
Per line Setup Window—Tetra Radio Configuration
The Per Line Setup window for Tetra Radio configuration, see Figure 115, appears when Tetra is selected from the Line
Type drop down menu on the Multicast Address Setup window. In Tetra mode, the following options are available for per line
configuration.
Jump To Entry Drop Down Menu
The Jump To Entry drop down menu allows you to select (in groups of 10) function tones to view and modify.
1. From the Jump To drop down menu, select the group of 10 function tones you want to view.
2. Click the Update button.
The function tones you select appears.
Update Button
The Update button searches and displays the selection you chose from the Jump To drop down list.
Tone Enable Check Box
The Tone Enable check box indicates whether or not the function tone is active. If selected, the function tone is active. The
frequency for the tone is set on the Tone Frequency and Durations window described on page 112. The standard function tones
and their frequencies are the default entries. These entries are shown in Table 7 on page 114.
NOTE: At least one (1) function tone must be selected.
FIGURE 115. Per Line Setup - Tetra Mode (view 1)
Function Tone Setup