Tyco 4100U-S1 - Manual (Page 51)

3-9
The 4100-6014 Network Interface Card (NIC) uses media cards to connect to other NICs.
This section describes how the media cards are mounted onto NICs.
NICs connect to each other via the two types of media cards. The types of media cards in
the right and left ports are determined by the type of wiring that is being used between
cards.
Connect P1 on the wired media card, or J1 on the fiber media cards, to P5 (the left port)
on the NIC.
To connect a second media card to the same NIC, connect it as described above, but use
P6 (the right port) on the NIC. Note that any two types of media cards can be connected
to the same NIC.
Figure 3-6. Media Card Mounting
The 4100 NIC daughter card inserts into motherboards as follows:
• If the 566-227 CPU Motherboard (default for 4100U-S1) or 565-275 CPU
Motherboard is used, the NIC daughter card is inserted into connector J2.
• If the 565-274 CPU Motherboard is being used, the NIC daughter card is
inserted into connector J1.
Step 2. Mounting Media Cards to the NIC
Overview
Media Card
Mounting
Step 3. Mounting Network Cards in the 4100U-S1
MEDIA CARDS
4100-6014 NETWORK
INTERFACE CARD
40-PIN
CONNECTION
(MEDIA CARD
P1 OR J1 TO
NIC P5)
40-PIN
CONNECTION
(MEDIA CARD
P1 OR J1 TO
NIC P6)
STANDOFFS FIT INTO HOLES