Teledyne 6712SR - Manual (Page 136)

6712SR Refrigerated Sampler
Section 6 SDI-12 Sondes
6-4
6.5 Sonde Setup - Storing
Parameter Data
Whether you are using a teledyne Isco Ready sonde or other
SDI-12 compatible sonde, you will need to tell the 6712 if you
want to store all of the parameter data or data from selected
parameters.
Data is stored in memory partitions. A fixed amount of memory
is available to store data. If you are using some parameters to
simply trigger an event or enable condition, it is not necessary to
store the data.
If all of the parameters’ data will fit in memory, you will be asked
if you want to store all of the parameter data. Answering “NO”
will still allow you to selectively store parameter data; otherwise,
all data will be stored.
You will be asked to store parameter data during the setup
process. You can also manually change the setup using options in
the Hardware menu.
To access the setup option in the Hardware menu, select Other
Function from the main menu, then choose Hardware. Advance
through the screens until you see one that displays SDI-12
DATA.
Connecting Other SDI-12
Sondes
3
SELECT ADDRESS OF
SONDE TO SETUP:
__ __ DONE
•Select the address of the
sonde you want to set up.
4
Company Model
Optional Information
SONDE AT ADDRESS __
HAS __ DATA VALUES
•You can wait a few seconds,
or press
↵
to advance to the
next screen:
5
DATA FROM SONDE __
1 = OTHER
2 = OTHER
3 = OTHER
--->
•Press an arrow key until the
cursor is on the data you
want to identify. Then, press
↵
. A scrolling screen listing
possible parameters will
appear.
6
SONDE ___ , DATA 1:
<-- pH
TEMPERATURE ( o C)
TEMPERATURE ( o F) --->
•Make your selection and
press
↵
.
3
DATA FROM SONDE __
<-- 1 = TEMPERATURE( o C)
2 = OTHER
3 = OTHER
--->
•Repeat the process until you
have defined all the data.
Press “
DONE ” when finished.
4
DATA FROM SONDE __
<--- 4 = pH
5 = LEVEL
DONE
•You will then be asked if you
want to store the parameter
data. Refer to “
SONDE SETUP
- STORING PARAMETER DATA ”
in the following paragraphs.