Teledyne 6712SR - Manual (Page 76)

6712SR Refrigerated Sampler
Section 4 Standard Programming
4-22
Table 4-3 Reports: Program Events, Source Codes, and Error Codes
* Indicates events and codes that occur in Standard Programming
Program Events
(listed in the order that they most likely would occur)
*Program Run The sampler ran the sampling program.
*Program Started The sampler started the sampling program.
*Program Enabled (Dis-
abled) The sampler was enabled or disabled according to program settings or an external
instrument.
‘A’/’B’ Enabled (Disabled) Program part ‘A’ or ‘B’ was enabled or disabled according to the program’s set-
tings.
Sample A sample was taken as programmed. (See Source Codes and Error Codes in this
table.)
*Sample Switch Time A sample was taken at programmed switch time.
*Program Done The sampler finished the sampling program.
‘A’/’B’ Done The sampler finished program part ‘A’ or ‘B’.
*Manual Pause Stop was pressed during the program to enter the Manual Paused state.
*Program Stopped You selected Stop from the manual paused options, terminating the program.
*Grab Sample A grab sample was taken while in the Manual Paused state.
Pump Tube Replaced The pump tube alarm was reset while in the Manual Paused state.
Calibrate Volume The volume was calibrated.
Calibrate SDI Parameter An SDI-12 sonde or module parameter was calibrated.
*Adjusted Pacing The pacing interval was changed while in the Manual Paused state.
*Volume Changed Sample volume was changed while in the Manual Paused state.
Adjust Enable Sampler enable thresholds were changed while in the Manual Paused state.
Reset Rain History The rain history was reset.
Adjust Suction Head The suction head was changed while in the Manual Paused state.
*Manual Resume The resume program option was selected from the Manual Paused state.
Program Paused (Resumed) The program reached a programmed pause or resume time.
‘A’/’B’ Paused (Resumed) Program part ‘A’ or ’B’ reached a programmed pause or resume time.
*Power Failed The power source was disconnected.
*Power Restored The power source was reconnected.
Alarm Occurred An alarm occurred.
Alarm Acknowledged An alarm was acknowledged.
*Missed Password The password was missed.