Teledyne 6712SR - Manual (Page 85)

6712SR Refrigerated Sampler
Section 4 Standard Programming
4-31
8
MODE OF OPERATION:
FLOWMETER
LEVEL ONLY
If you choose Flowmeter, proceed to screen #9 below.
If you choose LEVEL ONLY, proceed to screen #12.
9
WEIR FLUME
DATA POINTS
EQUATION MANNING
FLOW-INSERT
When you select Flowmeter, you will have several options for performing
the flow conversion.
For this example, choose Weir. Press
↵
.
10
V-NOTCH
RECTANGULAR
CIPOLLETTI
For this example, choose V-Notch. Press
↵
.
11
V-NOTCH WEIR ANGLE:
120 90 60
45 30 22.5
For this example, choose a Weir angle of 90. Press
↵
.
12
CURRENT LEVEL IS
__.__ ft
ADJUST LEVEL TO
__.__ ft
The current level will be displayed. Enter an adjustment if needed. If the
adjustment is different by more than 0.50 ft, you will be prompted “
ARE YOU
SURE ? YES NO ” Choose NO to re-enter; select YES if correct. Press
↵
.
13
NUMBER OF BOTTLES:
1 2 4 8 12 24
Select the number of bottles in your bottle kit by pressing either arrow key
until the correct number blinks. Press
↵
. For this example, select 24.
14
BOTTLE VOLUME IS
1000 ml (300-30000)
Type the volume for the bottles in your kit. For this example, 1000 is
correct, so simply press
↵
.
15
SUCTION LINE LENGTH
IS 10 ft
(3-99)
Type the length of the suction line, then press
↵
.
If you change the length, the sampler will display a message,
“PLEASE WAIT!. . . GENERATING PUMP TABLES.”
16
TIME PACED
FLOW PACED
Select FLOW PACED.
If the module is being used as a flowmeter, you will see screen #17a.
If the module is being used for level only, you will see screen #17b.
17 a
FLOW BETWEEN
SAMPLE EVENTS:
0.075 Mgal
(0.001 - 99999)
If the module is being used as a flowmeter, choose the amount of flow
between sample events.
Table 4-4 Programming Example With 730 Module Installed (Continued)